Research Article Open Access

ANALYSIS AND MONITORING METHODS OF TECHNOLOGICAL PREPARATION OF THE ADDITIVE PRODUCTION

Abstract

The driver for this research is the consideration of actual processes in the additive production, then the geometry of model may contain various types of mistakes to which led various processes. In order to exploit the potential benefits of this emergent technology, new design, analysis and optimization methods are needed. This paper presents identification of similar mistakes by all available methods extremely important at technological preparation since finally any mistake in geometrical representation of model involves mistakes fiber representation. The results demonstrate that using the considered control devices at each stage of technological preparation it is possible to reveal mistakes to an exit to the press that will allow to save time and material.

LEV N. RABINSKIY, АNDREY V. RIPETSKIY, SERGEY V. ZELENOV AND EKATERINA L. KUZNETSOVA

To read the full article Download Full Article | Visit Full Article